Set the suppression of the assembled item window

You can now specify that the view with the assembled item lines for the assembly should not be shown when you add an assembly.

You set this up in the entry layouts of the assembly and assembly preparation.

If you use this setting, Profit no longer automatically displays the subentry program for the assembled item on completion of a new assembled item line. If something has not been completed in the assembled item (stock, series, lot), the system does in fact given an error message, after which you still need to complete the assembled item.

This also applies to ‘Explosion’ articles.

To set the suppression of the assembled item window for assembly:

  1. Go to: General / Management / Entry layout.
  2. Open the assembly entry layout properties.
  3. Go to the tab: General settings.
  4. Go to the tab: Instellingen 2.
  5. Select the Suppress automatic composition screen check box.
  6. Click on: OK.

Perform this procedure for all the entry layouts for assembly and assembly preparation that you use.

Directly to

  1. Configure an assembly
  2. Activate assemblies
  3. Set up an assembly proposal
  4. Set the suppression of the assembled item window for assembly
  5. Use Assembly